Categories
Please select a category from the list below.

 

 

 

 

 

 

 

 

  FAQ's for General


What are these solutions?
Where can I buy the Phybridge UniPhyer solution?
What is the competition?
What is the service and support?
What is the warranty?
Who has tested the Phybridge UniPhyer?
Do these products support all major VoIP manufacturers?
Does the Phybridge UniPhyer support fiber interfaces?

What are these solutions?


The Phybridge UniPhyer is a Layer 2/3 Ethernet appliance that provides a complete parallel voice network over existing telephone cabling. The solution allows for a non disruptive, quick and easy way to deploy IP telephony and Unified Communications (UC) applications.

The Phybridge UniPhyer comes in both a 24 and 48 port models. The Phybridge PhyAdapters are common to both models. It is necessary to have one PhyAdapter for every active port on the Phybridge UniPhyer.


Back to top

Where can I buy the Phybridge UniPhyer solution?


Phybridge solutions are available through our Distribution Partners:

Our distributor are constantly growing, please visit the where to buy link for a detailed list or contacts and contact information.


Back to top

What is the competition?


There is no other solution on the market that enables VoIP and Unified Communications applications to be run on two wire legacy telephone cabling with all power provided by the central Bridge Unit.


Back to top

What is the service and support?


12 month replacement warranty is standard. 24 and 48 month PhyCare extended warranty options are available at time of purchase.


Back to top

What is the warranty?


12 month replacement warranty is standard. 24 and 48 month PhyCare extended warranty are available at time of purchase.


Back to top

Who has tested the Phybridge UniPhyer?


Multiple manufacturers, VARs and vendors have tested the Phybridge UniPhyer.


Back to top

Do these products support all major VoIP manufacturers?


Yes. Any IP PBX device is supported as the Phybridge UniPhyer is configured as a layer 2 switch.


Back to top

Does the Phybridge UniPhyer support fiber interfaces?


The UniPhyer will work with both Multi Mode Fiber (MMF) and Single Mode Fiber (SMF).

MMF uses different light frequencies, is for lower cost applications and for short distance runs (is used within a building or campus - 100 Mbit/s up to 2 kms and 1000 Mbit/s up to 500 meters. The UniPhyer will work for both of these network rates for voice bandwidth. The GBIC modules are MMF specific and use a lower cost technology.

Single Mode Fiber (SMF) is for higher precision, longer distance applications (more costly for cable and module technology used), 10 to 80 kms applications typically, MMF is orange cable, SMF is yellow cable.

The UniPhyer will work with both SMF and MMF, the limitation is in the GBIC module (rate)


Back to top

 

 

Become a Partner

Where to Buy

Free Voip Checklists - Is your network ready for IP Telephony?
What I needed to know about VoIP but was never told...

 

Site Map     Copyright ©  Phybridge Inc.
Avaya Cisco Mitel Polycom Westcon Group Jenne Novus  Broadcom  Zultys | Smarter Communications AvayaSynnexSynnex